Triax DVB 1000s Retune

dvb1000s

NB. A PIN number may be requested during the following procedures – it is usually “0000″ or “1234″.

1. Turn on the box and press the Menu button on the remote. The following screen appears.

triaxmain

2. Use the arrow keys to select Installation and press OK.

triaxinst

3. Use the arrow keys to select Transponder and press OK.

triaxtran

4.Use the up/down keys to select Transponder Number and the left/right keys to select the transponder with the correct Frequency/Symbol Rate/Polarization. If the required frequency is not listed simply go through the transponder numbers until New is shown, then fill in the frequency, symbol rate and polarization manually, highlight Save at the bottom of the screen and press OK. Move down to Scan and use the left/right keys to select FTA Only (only the free to air channels are scanned). Press OK to scan the selected transponder. After the transponder has been scanned the above screen will re-appear. Repeat with any other required frequencies.

NB. Any new channels and existing channels on the chosen transponder will be placed at the end of the channel list.

To re-order the channel list:

5. Go back to the Main Menu as in fig. 1 above (press EXIT until the correct screen appears). Select Channel Edit and press OK.

triaxcha1

6. Select TV Channel Edit and press OK.

triaxcha2

7. Use the left/right keys to select action (see below), up/down keys to select channels.

triaxcha3

Select the Delete channel icon and press OK to mark channels for deletion, press OK again to unmark channels. To move a channel select the Move channel icon, press OK on the required channel followed by the right key, then type the position to move the channel to. Repeat until all channels are in the required positions. Press EXIT when finished.

To re-order the radio channel list select Radio Channel Edit on the Channel Edit screen and repeat step 7