Technomate TM5200D Retune

tm5200d

NB. A PIN number may be requested during the following procedures – it is usually “0000″ or “1234″.

1. Turn on the box and press the Menu button on the remote.

5200main1

2. Installation should be highlighted, press the right arrow key, move down to Advance Search and press OK.

NB. A PIN number may be requested again during this procedures – it will be the same as before.

5200srch

3. Use the arrow keys to move down to Transponder, then use the left/right keys the select the required transponder. If the required transponder is not listed press the green key (Add TP), enter the frequency, symbol rate and polarization manually. Use the arrow keys to set the Search Type to FTA Only (only free to air channels will be scanned), and press the red key (SCAN). Repeat with other required transponders.

To re-order the channel list:

4. Go to the main menu as in fig. 1 above (press EXIT from the Advance Search screen and the left arrow key, Installation should be highlighted). Use the arrow keys to select Edit Channels and press the right arrow key.

5200main2

5. To delete unwanted channels move down to Delete Channels and press OK.

5200del

6. Press OK to select channels for deletion – a X will apppear next to each channel selected. The X can be removed by reselecting the channel and pressing OK again.

When all unwanted channels are selected press EXIT, at the confirmation prompt select OK and press OK. The screen in fig. 4 should now be visible again. Move up to Move Channels and press OK.

5200move

7. Select channel(s) to be moved by pressing OK. Now press the Info key – a yellow line will appear between the channels. Use the arrow keys to move the yellow line to the desired position and press OK to move the channels.